Troubleshooting - Eastwood CONTOUR SCT Instructions Manual

TROUBLESHOOTING

PROBLEM
Does Not Run
When Switch
is Turned On
Motor Runs
Too Slowly/
Develops Low
Power
Excessive
Noise and
Vibration
Motor
Overheats
Can't Loosen
Abrasive Drum
Retaining
Screw
10
CAUSE
No Power
Tripped Circuit
Breaker
Undersized
and/or too long
of an extension
cord used.
Drum is Likely
Damaged
Excessive
Pressure Being
Applied
Dirt and
Cutting Debris
Buildup in
Motor Cooling
Air Slots.
Retaining
Screw Uses A
Left-Handed
Thread
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
CORRECTION
Check 120 VAC input plug connection.
The Contour SCT operates on a 15 Amp minimum
circuit, 20 Amp is strongly recommended.
Use only 16 Gauge or larger cord and limit length
to 25'.
WARNING: This is an extremely unsafe condition!
Discontinue use and replace Drum!
Allow Contour SCT to cut by rotation alone.
Do not force.
Use a brush or compressed air to remove debris.
Turn Retaining Screw clockwise to remove.
See "DRUM REPLACEMENT" for additional
information.