Advertisement
CONTOUR SCT RACK
The EASTWOOD CONTOUR SCT RACK has been designed to conveniently hold an SCT and up to six
drums all in one easy to reach location.
• This unit must be securely mounted on a wall, cabinet, workbench etc., capable of holding
30lbs. [13.6kg.] plus pulling stresses from operation. The use of 1/4" screws or appropriately
sized bolts with washers and attachment to a structural member is highly recommended.
• If placing unit on a studded wall, attach to two studs using pre-cut, 15-3/4" spaced holes as
a guide.
• If attaching to a solid concrete or hollow block wall, the use of the proper anchors is required.
• For less secure mounting surfaces, the use of a 1" x 17" x 5" backer board affixed to the wall
is suggested as a mounting surface.
INSTRUCTIONS
Item #33328
Advertisement
Table of Contents
Related Manuals for Eastwood CONTOUR SCT RACK
Summary of Contents for Eastwood CONTOUR SCT RACK
- Page 1 CONTOUR SCT RACK INSTRUCTIONS The EASTWOOD CONTOUR SCT RACK has been designed to conveniently hold an SCT and up to six drums all in one easy to reach location. • This unit must be securely mounted on a wall, cabinet, workbench etc., capable of holding 30lbs.
- Page 2 • Check for possible interference with electrical lines, other utilities, or obstructions before mounting. • Do not mount in a location where the Contour SCT Rack may become an obstruction where head or bodily contact could cause injury. FALLING HAZARD! •...
Need help?
Do you have a question about the CONTOUR SCT RACK and is the answer not in the manual?
Questions and answers