Pcan-Lin Module - Peak PCAN-LIN Series User Manual

PCAN-LIN – User Manual
Appendix C Changes of
This section covers the most important changes of the hardware
and the software related to former versions.
C.1

PCAN-LIN Module

Property
Supply voltage
Max. bit rate RS-232
Microcontroller
(relevant for firmware
update)
LIN slave/master mode
(in Configuration Tool
"LIN Bus Termination")
C.2 PCAN-LIN Configuration Tool
Property
Entries on the Profiles
Management tab in the
LIN branch
Hardware/Software
Modules up to ser. no. 999
8 - 18 V DC
38,400 bit/s
XA-G49
LIN termination is swit-
ched; during transmission
of a LIN header the master
mode is automatically
used, independent from the
setting
Version 1
Number of Retries
Bit Recognition Status
Slave Mask
Slave ID + Data Configu-
ration: only a single ID
33
Modules from ser. no. 1000
9 - 30 V DC
115,200 bit/s
LPC2194
LIN termination is swit-
ched; master mode is expli-
citly switched on or off
Version 3
Dropped
No possibility for changing
anymore; always active
Integrated into table under
Frame Configuration
Entries possible for all IDs
under Frame Configuration