Figure 68. Rmp Dimensions - Eaton 9355 User Manual

Figure 68. RMP Dimensions

Dimensions are in mm [inches]
To install an RMP:
NOTE If mounting to a hollow wall, secure the enclosure bottom to a wood or metal stud
within the wall. Do not use hollow wall anchors. The RMP can also be mounted to a
single- or double-gang electrical box.
1. If wall mounting, securely mount the RMP. Proceed to
If desk mounting, install the provided bumpers to the bottom of the RMP enclosure. Proceed to
2. Install 1/2" conduit from the RMP to the IRC through the cable exit openings (see
Step 4.
3. Install wiring from the RMP to the IRC using the cable listed in
bushings in the cable exit openings in the IRC (see
4. Connect the wiring between the RMP and the IRC plug–in terminal blocks using terminations shown in
Table 8. See Figure 69
Cable Exit Openings
for 1/2" Conduit or
Provided Strain Relief
(3 places)
Matches mounting holes on a single- or
double-gang electrical box.
and Figure 70 for plug–in terminal block locations.
Eaton 9355 UPS (10/15 kVA) User's Guide 164201594—Rev H0
Mounting Slots
(6 places)
Step 2.
Table 8 and the provided strain relief
Figure 70) and the RMP.
Communication
Step 3.
Figure 68). Proceed to
81