C C h h a a p p t t e e r r 6 6 C C o o m m m m u u n n i i c c a a t t i i o o n n
This section describes the:
•
DB-9 communication port
•
X-Slot cards
•
Remote Monitor Panel and Industrial Relay Card (IRC)
•
LanSafe Power Management Software
•
Remote emergency power-off (REPO)
•
Relay output contacts
•
Programmable signal inputs
Figure 60
Figure 60. Communication Options and Control Terminals
6 6 . . 1 1
I I n n s s t t a a l l l l i i n n g g C C o o m m m m u u n n i i c c a a t t i i o o n n O O p p t t i i o o n n s s a a n n d d C C o o n n t t r r o o l l T T e e r r m m i i n n a a l l s s
To access and install the communication options and control terminals:
1.
Remove the front covers of all cabinets, starting with the top cabinet.
Press and release the handle latch at the bottom of each cover and then lift the cover up and off the
cabinet (see
shows the location of the communication options and control terminals on the UPS.