Figure 45. Communication Options And Control Terminals; Industrial Relay Card - Eaton 9355 User Manual

C C h h a a p p t t e e r r 6 6 C C o o m m m m u u n n i i c c a a t t i i o o n n
This section describes the:
• DB-9 communication port
• X-Slot cards
• Remote Monitor Panel (RMP) and Industrial Relay Card (IRC)
• LanSafe
• Remote emergency power-off (REPO)
• Relay output contacts
• Programmable signal inputs
• Parallel Communication
Figure 45

Figure 45. Communication Options and Control Terminals

REPO (normally open)
Signal Input 2
Signal Input 1
DB-9 Communication Port
6 6 . . 1 1 I I n n s s t t a a l l l l i i n n g g C C o o m m m m u u n n i i c c a a t t i i o o n n O O p p t t i i o o n n s s a a n n d d C C o o n n t t r r o o l l T T e e r r m m i i n n a a l l s s
To access and install the communication options and control terminals:
1. Remove the UPS front door (see paragraph
2. Install the appropriate X-Slot card and/or necessary cables into the ports (see
3. Route the control terminal cable(s) through the middle of the fan section and secure in the cable clips.
® Power Management Software
shows the location of the communication options and control terminals on the UPS.
REPO (normally closed)
Relay Output Contacts
NOTE To install a CAN Bridge Card, see paragraph
X-Slot
Communication
Bay #1
Control
Terminals
Pull-Chain Output
Contacts (parallel only)
4.2 Removing and Replacing the Front
Eaton 9355 UPS (20/30 kVA) User's Guide 164201626—Rev H0
6.4 Parallel Communication.
Doors.
Figure 45
X-Slot
Communication
Bay #2
and Figure 46).
69