Table of Contents
Advertisement
10
IMPORTANT WARNINGS
1.
The boiler may only operate persons familiarized with this instruction manual. It is not allowed to leave children beyond control
of adults near the boiler. Interventions into the boiler structure which could threaten the health of the servicing person or his/her
inmates are not allowed.
2.
The boiler is not determined for using by persons (including children), whose physical, sensible or intellectual inability or
absence of experience and knowledge prevents from safety using of the consumer, until they are under supervision or until they
are instructed of using of the consumer by a person responsible for their safety.
You should watch the children to ensure that they don't play with the consumer.
3.
4.
In case there is a danger of creation and intrusion of flammable steams or gas into the boiler room, or at work during which
there is a transition danger of fire or explosion (floor coating cementing, coating with flammable paintings), the boiler has to be
timely shut-down prior the start of such works.
5.
IT IS prohibited to use flammable liquids for kindling.
6.
DURING OPERATION, IT IS prohibited to overheat the boiler.
Don't put any objects made of flammable material on the boiler and within a distance smaller than the safe distance from it.
7.
8.
While taking out ash from the boiler, no flammable materials can be placed on the distance less than 1500 mm from the boiler.
While operating the boiler at temperature lower than 50 °C can occur fogging of the boiler drum, so called low-temperature
9.
corrosion, which shortens the service life of the boiler drum. That's why we recommend that you operate the boiler at
temperature of 50 °C and higher.
10.
In case of the use of an accumulating tank, it is possible to kindle the boiler again or to add fuel to it again provided the boiler is
burnt up to the base of the furnace and the accumulating tank is discharged or cooled.
WARNING!!! Failure to respect brings to extremal pollution of the heat-exchanger.
11.
After having finished the heating season, it is necessary to thoroughly clean up the boiler, flue gas ducting and chimney pot.
Lubricate with graphite grease as follows: pivots, flue gas shutter mechanism and other movable parts on the boiler. It is
necessary to maintain the boiler room in clean and dry conditions.
12.
In case that the heating system is not used daily during the winter period, it is necessary to pour out water.
13.
Possible signs of corrosion on the boiler drum are not a defect and do not affect boiler functionality.
14.
A safety valve with the maximum overpressure of 400 kPa (4 bar), the dimensions of which have to comply to the nominal power
of the boiler, has to be installed in the system. The safety valve must be positioned directly behind the boiler. No shut-off valve
can be placed between the safety valve and the boiler. In case of other questions, please contact our contractual mounting
companies and service organizations.
In case of triggering the two-way safety device, when water which does not comply with requirements of ČSN 07 7401 can be
15.
refilled, it is necessary to prepare water in the system so that it met the requirements of this standard.
16.
During assembly, installation and operation of the appliance it is necessary to comply with
standards applied in the relevant country of destination.
In case of violation of these conditions, no warranty repairs can be required.
The list of contractual service organizations is at your disposal at the web-pages of www.viadrus.cz.
11
Instructions for product liquidation after the lapse of its service life
VIADRUS a.s. is a contractual partner of company EKO–KOM a.s. with the client number F00120649.
The packages comply with ČSN EN 13427.
We recommend liquidating packages by the following method:
plastic film, cardboard cover – please use salvage points
-
metal tightening tapes – please use salvage points
-
-
wooden basement, it serves for one use, and it cannot be further used as a product. Its liquidation is a subject of the law 477/ 2001 Sb. and
185/2001 Sb., subsequently amended.
We recommend liquidating separate parts of the boiler as followed:
the heat-exchanger (grey cast-iron) – please use salvage points,
-
pipeline distributions, claddings – please use salvage points,
-
other metal parts – please use salvage points,
-
insulation materials – by means of a company acting in collection and liquidation of waists.
-
On loss of useful features of the product, you can use backward withdrawal of the product (if implemented), in case of a declaration
of the producer that this is a waist; manipulation with this waist is to be according to the valid legislation of a corresponding country.
21
Hide quick links:
Advertisement
Table of Contents
