Coolant - Yamaha XMAX Owner's Manual

6. Install the final transmission oil
drain bolt and its new gasket, and
then tighten the bolt to the speci-
fied torque.
Final transmission oil drain bolt:
20 N·m (2.0 kgf·m, 15 lb·ft)
7. Refill with the specified amount of
the recommended final transmis-
sion oil.
[EWA11312]
See page 10-1.
0.20 L (0.21 US qt, 0.18 Imp.qt)
8. Install the final transmission oil fill-
er cap and its new O-ring, and
then tighten the oil filler cap.
9. Check the final transmission case
for oil leakage. If oil is leaking,
check for the cause.
The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
1. Place the vehicle on the center-
stand.
The

coolant

level must
checked on a cold engine since
the level varies with engine tem-
perature.
Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Check the coolant level through
the check window.
8-13
EAU20071
The coolant should be between the mi-
nimum and maximum level marks.
EAU78580
1
be
1. Coolant level check window
2. Maximum level mark
3. Minimum level mark
3. If the coolant is at or below the mi-
nimum level mark, remove the left
floorboard mat by pulling it up.
2
3