Sidestand - Yamaha XMAX Owner's Manual

Each shock absorber assembly is
equipped with a spring preload adjust-
ing ring.
NOTICE
Adjust the spring preload as follows.
To increase the spring preload and
thereby harden the suspension, turn
the adjusting ring on each shock ab-
sorber assembly in direction (a). To de-
crease the spring preload and thereby
soften the suspension, turn the adjust-
ing ring on each shock absorber as-
sembly in direction (b).
Align the appropriate notch in the
adjusting ring with the position in-
dicator on the shock absorber.
Use the spring preload adjusting
tool included in the owner's tool
kit to make this adjustment.
EAU14893
1 (a)
EWA10211
1
2
3
4
5
3
1. Spring preload adjusting ring
2. Special wrench
3. Position indicator
ECA10102
Minimum (soft):
1
Standard:
3
Maximum (hard):
5
5-23
The sidestand is located on the left
(b)
side of the frame. Raise the sidestand
2
or lower it with your foot while holding
the vehicle upright.
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
EAU15306
EWA10242