Coolant - Yamaha FJR1300AE 2015 Owner's Manual

Periodic maintenance and adjustment
2
3
1. Final gear oil filler bolt
2. Gasket
3. Final gear oil drain bolt
4. Install the final gear oil drain bolt
and its new gasket, and then tight-
en the bolt to the specified torque.
Tightening torque:
Final gear oil drain bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
5. Refill with the recommended final
gear oil to the brim of the filler
hole.
Recommended final gear oil:
Yamaha genuine shaft drive gear oil
SAE 80W-90 API GL-5
Oil quantity:
0.20 L (0.21 US qt, 0.18 Imp.qt)
6. Check the oil filler bolt gasket for
damage, and replace it if neces-
sary.
7. Install the oil filler bolt and its gas-
ket, and then tighten the bolt to
the specified torque.
Tightening torque:
Final gear oil filler bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
8. Check the final gear case for oil
leakage. If oil is leaking, check for
the cause.

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
1
ant must be changed at the intervals
specified in the periodic maintenance
2
and lubrication chart.
To check the coolant level
1. Place the vehicle on the center-
stand.
TIP
 The
coolant
checked on a cold engine since
the level varies with engine tem-
perature.
 Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Remove the left cowling vent pan-
el. (See page 4-36.)
3. Check the coolant level in the
coolant reservoir.
TIP
The coolant should be between the mi-
nimum and maximum level marks.
1
1. Coolant reservoir
2. Maximum level mark
3. Minimum level mark
7-15
EAU20071
EAU54163
level must be
2
3
7