GasTech 24kW Baykan Starplus Manual page 5

"A" – ON-OFF switch
"B" – Tap water temperature adjustment switch
"C" – Heating water temperature adjustment button
"D" – SUMMER– WINTER function selection switch
"E" – RESET Button
"F" – Switch sensitive for time
If it is connected when temporarily pressed,
the data concerning the external thermostat
will be processed and if held for 5 seconds,
DUCT CLEANING FUNCTION will be active
and if pressed for 5 seconds, Access to
SETUP menu will be maintained.
FIRST TIME IGNITION OF DEVICE
- Press switch "A" to ignite the wall hung boiler.
- By pressing "D" button, select the desired mode among SUMMER or WINTER modes, the selected
mode will be displayed with the corresponding symbols on the screen.
- If WINTER mode is selected, the boiler will automatically turn on whenever there is need for the boiler
to warm or whenever there is need for tap water.
If the SUMMER mode has been selected, the boiler will only turn on when there is need for hot tap
water.
- Select SUMMER mode.
- Turn your hot water tap on, at this point the wall hung boiler will access to combustion phase, if
everything goes right, a symbol (5) will be displayed on the screen displaying that there is flame. If
the burning of boiler can not be observed, a line will be present on the screen above the flame
symbol (8). In order to remedy this situation, repeat the combustion ignition circle by pressing "E"
RESET button.
CAUTION: Before the wall hung boiler gives an alarm concerning the blocking situation, it
repeats the ignition circulation three times automatically.
ADJUSTING THE TEMPERATURE OF WATER TO BE USED
In order to adjust the temperature of the tap water, rotate the "B" switch clockwise for increasing the
temperature, rotate it counter clockwise to decrease the temperature., the change of temperature will be
displayed on screen marked with 3, the said temperature will only be displayed on the screen when
there is need for tap water. The adjustment made will be valid both when working in summer or winter
modes.
BAYKAN ISI SIST.SAN.TIC. AS.
7
1 2 8 3
4
1 – Displays the temperature of heat to be used or
menu pages.
2 – Displays the pressure of heating system or
when connected, displays the temperature of
external thermostat temperature and if the letter "E"
follows it displays and indicates the presence of an
extraordinary condition.
3– Displays the temperature of heating system and t
value on the selected menu page.
4 – Displays if there are any remote controls.
5 – Displays if there is any flame.
6 – Displays if there is need for technical
intermeddling or service.
7 – Displays if there are any external thermostats
8 – Displays the blocking or that the ignition has not
been performed.
- 20 -
5 6