Control Panel Diagrams; First Time Ignition Of Wall Hung Boiler; Adjusting The Temperature Of Water To Be Used; Adjusting The Temperature Of Water In The Heating System - GasTech 24kW Baykan Starplus Manual

3.1 CONTROL PANEL (star-starplus)
Figure Nr. 13
"A" –DUCT CLEANING function with OFF/RESET
switch and SUMMER-WINTER functions.
"B" – Adjustment switch for setting the
temperature of water to be used
"C" – Adjustment switch for the central heating
system
"D" – MANOMETER (Pressure gauge)

FIRST TIME IGNITION OF WALL HUNG BOILER

By turning the selector marked with "A", the operation of the wall hung boiler in SUMMER or WINTER
modes is maintained. If the WINTER mode is selected, whenever there is need for heating or use of
hot water to use, the boiler will automatically turn on. If the SUMMER FUNCTION is selected, the
boiler will only turn on when the hot water to be used is demanded.
Turn the selector marked with letter "A" and change the mode of wall hung boiler to SUMMER mode.
- Turn the hot water tap on, at which point the wall hung boiler will change to burning phase. If
everything goes right, LED number 2 will glow which means there is flame, if the boiler does not
ignite, LED number 8 will flash, this indicates that the ignition has not been performed. To remedy
this situation and start the ignition cycle again, turn the "A" selector to OFF/R RESET position
momentarily and rotate it to SUMMER function again.
Caution: Before Wall hung boiler indicates blocked position, the igniting circle repeats itself
three times.

ADJUSTING THE TEMPERATURE OF WATER TO BE USED

In order to select the temperature of water to be used; rotate the button marked with "B" in counter
clockwise direction to decrease the temperature and rotate it clockwise to increase the temperature; the
adjustments made will be valid in both summer and winter modes.
ADJUSTING THE TEMPERATURE OF THE WATER IN THE HEATING SYSTEM
In order to adjust the temperature of central heating system; rotate the button marked with "C" ;
clockwise in order to increase the temperature and counter clockwise in order to decrease the
temperature, the temperature of the water in the heating system can be observed by the flashing of leds
3-4-5-6-7-8 in turn. The adjustment made will only be valid while running at winter mode.
3.2 CONTROL PANEL OF MOON MODEL (moon)
BAYKAN ISI SIST.SAN.TIC. AS.
34 5 6 7 8
1 2
1 – Power Led
2 – Led which displays there is flame
3-4-5-6-7-8 – Fixed Leds indicate a failure or
malfunction
temperature flashes.
- 18 -
if the heating installation