Canon iPF800 Series Service Manual page 82

Chapter 1
[Interface Setup]
[EOP Timer]
[TCP/IP]
[NetWare]
[AppleTalk]
[Ethernet Driver]
[Ext.Interface]
[Init. Settings]
[Maintenance]
[Maint. cart.]
[Replace P.head]
[Repl. S. Cleaner]
[Move Printer]
1-68
Setting Item
[TCP/IP]
[IP Mode]
[Protocol] [DHCP]
[BOOTP]
[RARP]
[IP Setting] [IP Address]
[Subnet Mask]
[Default G/W]
[NetWare]
[Frame Type]
[Print Service]
[Auto Detect]
[Comm.Mode]
[Ethernet Type]
[Spanning Tree]
[MAC Address]
Setting Item
T-1-46
Specify the timeout period before cancellation of print jobs that
cannot be received by the printer.
Specify the TCP/IP protocol settings. To apply your changes,
choose Register Setting.
Choose whether the printer IP address is configured
automatically or a static IP address is entered manually.
Specify the protocol used to configure the IP address
automatically.
Specify the printer network information when using a static IP
address.
Enter the IP address assigned to the printer, as well as the
network subnet mask and default gateway.
Specify the NetWare protocol. To apply your changes, choose
Register Setting.
Specify the frame type to use.
Choose the print service.
Specify whether to use the AppleTalk protocol. To apply your
changes, choose Register Setting.
Specify the communication method. To apply your changes,
choose Register Setting.
Choose On for automatic configuration of the LAN
communication protocol. Choose Off to use settings values of
Comm.Mode and Ethernet Type.
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported over the
LAN.
Displays the MAC address.
When installing the expansion interface board, choose whether
the expansion interface board is used.
A confirmation message is displayed if you press the button.
Choose [OK] to restore the network settings to the default values.
T-1-47
Description, Instructions
When exchanging the maintenance cartridge, choose Yes and follow the instructions on the
screen.
Not displayed during a warning message that the remaining Maintenance Cartridge capacity is
low.
When replacing the Printhead, choose Yes and follow the instructions on the screen.
When replacing the Shaft Cleaner, choose Yes and follow the instructions on the screen.
When transferring the printer to another location, choose the level of transfer and follow the
instructions on the screen.
Description, Instructions