Canon iPF800 Series Service Manual page 80

Chapter 1
[GL2 Settings]
[Color Mode]
[Print Quality]
[Print (Economy)]
[Input Resolution]
[Paper Source]
[Conserve Paper]
[Line Cap]
[Smoothing]
[Line Width]
[ThickenFineLines]
[AdjustFaintLines]
[Auto Rotate]
[Nesting]
[On-the-Fly]
1-66
Setting Item
[Monochrome]
[Color(CAD)1]
[Color(CAD)2]
[Color(CAD)3]
[Color(CAD)4]
[Color(CAD)5]
[Color(CAD)6]
[Use Nesting]
[Nesting WaitTime]
[Cut Lines]
T-1-44
Description, Instructions
Print by the monochrome.
Print by the standard color.
Print by the bright color.
Print by the color emulated the Canon BJ-W3000/W3050.
Print by the color emulated the HP Designjet 500/800.
Print by the color emulated the HP Designjet 1000.
Print by the color emulated the HP Designjet 4000/4050.
Select the print quality.
Prints with a lower grade of print than normal, but with less ink consumption. Select [ON] to
economize on inks.
Choose the printer input resolution from between [600dpi] and [300dpi].
Select how to feed paper for printing on the HP-GL/2.
Prints by economizing on paper.
Choose the shape of the end of a line from between [Software] and [Rounded].
Choose whether to draw an arc with a smooth curve or with a polygon.
Select the width of each line to print for data that does not have a line width specified. The line
width is expressed in increments of 300 dpi.
Select [On] to print thin lines clearly.
If thin lines print in a tint of color varied from other patterns, selecting [Off] may provide the
print result as intended, though the thin lines may print, interrupted, depending on the color.
If a document has its long side shorter than the roll width, the page rotates by 90 degrees
automatically to economize on paper. If a document contains horizontally long data such that
it has its long side longer than the roll width and its short side shorter than the roll width, the
page rotates 90 degrees to print within the boundaries of the paper.
HP RTL cannot rotate.
Select [On] to print pages when they are tiled fully to the roll width, instead of printing them
one by one.
Set the time to elapse before printing.
Select [On] to print perforated lines between pages.
In printing data consisting solely of HP RTL, if the data is slow to print, select [On] to expedite
the time at which the data starts printing. Verify the print result to make sure that images are
not chipped in this case.