Epilog Laser Fusion Manual page 5

Procedure B: Adjusting the Front Corners
Step 1: Move the Lens Carriage.
Use the Up and Down Arrow Keys on the Key Pad to place the engraver into Jog
mode. Use the Joystick to move the Lens Carriage to whichever Front Corner of the
engraver requires adjustment.
Step 2: Open the Front Panel
Open the Front Drop-Down Panel of the engraver so that you can access the
underside of the table.
Step 3: Locate the Table Level Adjuster
Look at the bottom of the table and locate the Table Level Adjusters. There is
one on the Left and one on the Right sides of the table.
Adjusting the Table Level
Fusion and FiberMark Fusion
Revision Date: 9/10/2014 pg. 5 of 10