Epilog Laser Fusion Manual page 3

Step 3: Focus on Reference Corner
Use the Up and Down Arrow Keys on the Key Pad to place the engraver into
Focus mode. Use the Joystick to move the Table until it just touches the Manual Focus
Gauge.
Step 4: Check Focus on Each Corner
Use the Up and Down Arrow Keys on the Key Pad to place the engraver into Jog
mode. Use the Joystick to move the Lens Carriage to each corner of the engraver. If the
table is still barely touching the Manual Focus Gauge in each corner, the table level is
good. If the table drops away or rises up as you move the Lens Carriage, please
continue to the next procedure.
Adjusting the Table Level
Fusion and FiberMark Fusion
Revision Date: 9/10/2014 pg. 3 of 10