Toro Reelmaster 5410 Operator's Manual page 52

3. Make initial reel-to-bedknife adjustments
appropriate for backlapping on all cutting units
which are to be backlapped; refer to the cutting
unit Operator's Manual.
4. Start the engine and run at low idle speed.
DANGER
Changing the engine speed while
backlapping may cause the reels to stall.
• Never change the engine speed while
backlapping.
• Only backlap at idle engine speed.
5. Select either the front, rear, or both backlap
levers to determine which units to backlap
(Figure 72).
DANGER
To avoid personal injury, be certain that
you are clear of the cutting units before
proceeding.
6. With the Mow/Transport lever in the M
position, move the Enable/Disable switch to
the E position. Move the Lower Mow/Lift
NABLE
control forward to start the backlapping operation
on the designated reels.
7. Apply lapping compound with a long-handled
brush.
Note:
Never use a short-handled brush.
8. If the reels stall or become erratic while
backlapping, select a higher reel-speed setting
until the speed stabilizes, then return the reel
speed to your desired speed.
9. To make an adjustment to the cutting units
while backlapping, turn the reels off by moving
the Lower Mow/Raise lever rearward and the
Enable/Disable switch to the D
and stop the engine.
After completing the adjustments, repeat steps
4 through 8.
10.
OW
11.
position,
ISABLE
52
Figure 72
1. Backlap levers
Repeat the procedure for all cutting units you
want to backlap.
When finished, return the backlap levers to the
M position, lower the seat, and wash all
OW
lapping compound off the cutting units.
Note:
Adjust cutting unit reel to bedknife as
needed. Adjust the cutting-unit reel speed to the
desired mowing setting.
Important:
If the backlap switch is
not returned to the O
backlapping, the cutting units do not raise
or function properly.
Note:
For a better cutting edge, run a file across
the front face of the bedknife after lapping. This
removes any burrs or rough edges that may
have built up on the cutting edge.
g021209
position after
FF