WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from it.
Keep the terminals and the entire battery case clean
because a dirty battery will discharge slowly. To clean
the battery, wash the entire case with a solution of
baking soda and water. Rinse it with clear water.
Fuses
There are 8 fuses in the electrical system. The fuse
block
(Figure
52) is located behind the control arm
access panel.
Figure 52
1. Fuse block
Figure 53
Drive System
Maintenance
Checking the Torque of the
Wheel Nuts
Service Interval: After the first hour
After the first 10 hours
Every 250 hours
Torque the wheel nuts to 94 to 122 N-m (70 to 90 ft-lb).
WARNING
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Adjusting the Traction
Drive for Neutral
The machine must not creep when the traction pedal
is released. If it does creep, adjust as follows:
1.
Park the machine on a level surface, stop the
engine, and lower the cutting units to the ground.
2.
Jack up the front of the machine until the
front tires are off the shop floor. Support the
machine with jack stands to prevent it from
g003988
falling accidentally.
Note:
must also be off the ground.
3.
On the right side of the hydrostat, loosen the
locknut on the traction-adjustment cam
54).
decal117-0169
42
On 4-wheel-drive models, the rear tires
(Figure