Replacing The Hydraulic Filters - Toro Reelmaster 5410 Operator's Manual

2. Place a large drain pan under the fitting secured
to the bottom of the hydraulic-fluid reservoir
(Figure 65).
Figure 65
1. Hose
3. Disconnect the hose from the bottom of the
fitting and let the hydraulic fluid flow into the
drain pan.
4. Install the hose when hydraulic fluid stops
draining.
5. Fill the reservoir with approximately 56.7 L (15
US gallons) of hydraulic fluid; refer to
the Hydraulic-Fluid Level (page 48)
Important:
Use only the hydraulic fluids
specified. Other fluids could cause system
damage.
6. Install the reservoir cap.
7. Start the engine and use all of the hydraulic
controls to distribute hydraulic fluid throughout
the system. Also check for leaks.
8. Stop the engine.
9. Check the level of the hydraulic fluid and add
enough to raise level to the Full mark on the
dipstick.
Important:
Do not overfill the reservoir.
Replacing the Hydraulic
Filters
Service Interval: Every 800 hours (Or more often if
The hydraulic system is equipped with a
service-interval indicator
running at operating temperature, view the indicator, it
should be in the green zone. When the indicator is in
the red zone, change the hydraulic filters.
g004139
1. Hydraulic-filter-restriction indicator
Checking
Important:
warranty on some components.
1. Position the machine on a level surface, lower
the cutting units, stop the engine, engage the
parking brake, and remove the key from the
ignition switch.
2. Clean the area around the filter mounting area
and place a drain pan under filter
Figure
1. Hydraulic filter
49
the service-interval indicator is in
the red zone).
(Figure 66). With the engine
Figure 66
Use of any other filters may void the
68).
Figure 67
g004132
(Figure 67 and
g003980