Toro Reelmaster 5410 Operator's Manual page 22

InfoCenter Revision
CAN Bus
Protected Menu
There are 5 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
Blade Count, Mow Speed, Height of Cut (HOC), F
Reel RPM, and R Reel RPM. These settings can be
locked by using the Protected Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Accessing the Protected Menu
Settings
1. From the Main Menu, scroll down to the Settings
Menu and press the right button.
2. In the Settings Menu, scroll down to the
Protected Menu and press the right button.
3. To enter the passcode, use the center button to
set the first digit then press the right button to
move on to the next digit.
4. Use the center button to set the second digit
then press the right button to move on to the
next digit.
5. Use the center button to set the third digit then
press the right button to move on to the next
digit.
6. Use the center button to set the fourth digit then
press the right button.
7. Press the middle button to enter the code.
8. If the code has been accepted and the protected
menu has been unlocked, "PIN" will be displayed
in the upper right corner of the display screen.
Note:
If the passcode has been forgotten or
misplaced, please contact your distributor for
assistance.
Viewing and Changing the
Protected Menu Settings
1. In the Protected Menu, scroll down to Protect
Settings.
2. To view and change the settings without entering
a passcode, use the right button to change the
Protect Settings to O
3. To view and change the settings with a
passcode, use the left button to change the
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
.
FF
Protect Settings to O
turn the key in the ignition switch to the O
position and then to the O
Setting the Blade Count
1. In the Settings Menu, scroll down to Blade Count
2. Press the right button to change the blade count
between 5, 8, or 11 blade reels.
Setting the Mow Speed
1. In the Settings Menu, scroll down to Mow Speed.
2. Press the right button to select mow speed.
3. Use the center and right button to select the
appropriate mow speed set on the mechanical
mow-speed limiter on the traction pedal.
4. Press the left button to exit mow speed and save
the setting.
Setting the Height of Cut (HOC)
1. In the Settings Menu, scroll down to HOC.
2. Press the right button to select HOC.
3. Use the center and right button to select the
appropriate HOC setting. (If the exact setting is
not displayed, select the nearest HOC setting
from the list displayed).
4. Press the left button to exit HOC and save the
setting.
Setting the Front and Rear Reel
Speeds
Although the front and rear reel speeds are calculated
by inputting the number of blades, mow speed and
HOC into the InfoCenter, the setting can be manually
changed to accommodate for different mowing
conditions.
1. To change the Reel Speed Settings, scroll down
to the F Reel RPM, R Reel RPM, or both.
2. Press the right button to change the reel speed
value. As you change the speed setting, the
display continues to show the calculated reel
speed based on blade count, mow speed and
HOC, which was previously entered, but the
new value is also displayed.
22
, set the passcode, and
N
FF
position.
N