During Operation; During Operation Safety - Toro Reelmaster 5410 Operator's Manual

Use summer-grade diesel fuel (No. 2-D) at
temperatures above -7°C (20°F) and winter-grade
fuel (No. 1-D or No. 1-D/2-D blend) below that
temperature.
Note:
Use of winter-grade fuel at lower temperatures
provides lower flash point and cold flow characteristics
which eases starting and reduces fuel filter plugging.
Using summer-grade fuel above -7°C (20°F)
contributes toward longer fuel pump life and increased
power compared to winter-grade fuel.
Biodiesel
This machine can also use a biodiesel blended fuel of
up to B20 (20% biodiesel, 80% petroleum diesel).
Sulfur content: Ultra-low sulfur (<15 ppm)
Biodiesel fuel specification: ASTM D6751 or
EN14214
Blended fuel specification: ASTM D975, EN590,
or JIS K2204
Important:
The petroleum diesel portion must
be ultra-low sulfur.
Observe the following precautions:
•
Biodiesel blends may damage painted surfaces.
•
Use B5 (biodiesel content of 5%) or lesser blends
in cold weather.
•
Monitor seals, hoses, gaskets in contact with fuel
as they may be degraded over time.
•
Fuel filter plugging may be expected for a time
after converting to biodiesel blends.
•
Contact your Authorized Toro Distributor if you
wish for more information on biodiesel.
Adding Fuel
1. Park the machine on a level surface, lower the
cutting units, shut off the engine, and remove
the key.
2. Using a clean rag, clean area around fuel-tank
cap.
3. Remove the cap from the fuel tank
1. Fuel-tank cap
4. Fill the tank until the level is 6 to 13 mm (1/4 to
1/2 inch) below the bottom of the filler neck.
5. Install the fuel-tank cap tightly after filling the
tank.
Note:
If possible, fill the fuel tank after each use.
This minimizes possible buildup of condensation
inside the fuel tank.

During Operation

During Operation Safety

General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Before you start the engine, ensure that all drives
are in neutral, the parking brake is engaged, and
you are in the operating position.
25
(Figure
Figure 28
28).
g021210