Toro Reelmaster 5410 Operator's Manual page 13

Note:
When installing or removing the
cutting units, make sure the hairpin cotter is
installed in the spring rod hole next to the
rod bracket. Otherwise, the hairpin cotter
must be installed in the hole in the end of
the rod.
6. Lower all lift arms completely.
7. Remove the snapper pin and the cap from the
lift-arm pivot yoke
Figure 10
1. Snapper pin
8. For the front cutting units, slide a cutting unit
under the lift arm while inserting the carrier-frame
shaft up into the lift-arm-pivot yoke
Figure 11
1. Lift arm
2. Carrier-frame shaft
9. Use the following procedure on the rear cutting
units when the height of cut is above 19 mm
(3/4 inch).
A. Remove the lynch pin and washer securing
the lift-arm-pivot shaft to the lift arm and
(Figure 10).
2. Cap
(Figure
3. Lift-arm-pivot yoke
slide the lift-arm-pivot shaft out of the lift
arm
1. Lynch pin and washer
B. Insert the lift-arm yoke onto the carrier-frame
shaft
C. Insert the lift-arm shaft into the lift arm and
secure it with the washer and lynch pin
(Figure
10. Insert the cap over the carrier-frame shaft and
lift-arm yoke.
g003975
11. Secure the cap and the carrier-frame shaft to the
lift-arm yoke with the snapper pin
Note:
Use the slot if a steering cutting unit is
desired or use the hole if the cutting unit is to
be locked in position.
11).
12. Secure the lift-arm chain to the chain bracket
with the snapper pin
Note:
Use the number of chain links described
in the cutting unit Operator's Manual.
1. Lift-arm chain
g003977
2. Chain bracket
13. On cutting unit 4 (left front) and cutting unit 5
(right front), insert the reel-motor hoses into the
respective hose guide.
14. Coat the spline shaft of the reel motor with clean
grease.
15. Oil the reel motor O-ring and install it onto the
motor flange.
13
(Figure 12).
Figure 12
(Figure 11).
12).
(Figure 13).
Figure 13
3. Snapper pin
g003979
(Figure 10).
g003948