Toro Reelmaster 5410 Operator's Manual page 12

Figure 5
1. Turf-compensation spring
2. Rod bracket
B. Remove the flange nut securing the
spring-tube bolt to the carrier-frame tab
(Figure 5) Remove the assembly.
C. Mount the spring-tube bolt to the opposite
tab on the carrier frame and secure with the
flange nut. The bolt head is to be positioned
to the outer side of the tab as shown in
Figure 6.
Figure 6
1. Opposite carrier-frame tab
D. Mount the rod bracket to the cutting-unit
tabs with the carriage bolts and nuts
6).
Important:
On the #4 (left front) and
#5 (right front) cutting units
use the rod-bracket mounting nuts to
1. Hose guides must lean toward the center cutting unit.
g003949
3. Spring tube
g003967
2. Rod bracket
(Figure
(Figure 7),
install the hose guides to the front of the
cutting-unit tabs
guides should lean toward the center
cutting unit
1. Hose guide (cutting unit 4
shown)
2. Rod bracket
Figure 9
12
(Figure 8). The hose
(Figure 8 and Figure
Figure 7
Figure 8
3. Nut
9).
g014684
g015160
g019284