What To Do If - RADEMACHER RolloTron Standard Series Operating And Assembly Manual

i

17. What to do if... ?

Fault
... the roller shutter belt winder indicates no functions?
... the roller shutter belt winder fails to react at the
configured switching time?
... the control LED flashes?
... the roller shutters no longer stop at the configured
end points?
... the roller shutters stop as soon as the control key is
released?
... the roller shutter belt winder rotates in the wrong
direction?
... the control LEDs flashes and the roller shutter belt
winder fails to operate in any direction.
Possible cause / solution
Check the power supply including connecting cable and plug.
a) There may have been a power failure. Reconfigure the switching
times, see page 93.
b) The end points may not be configured. Reconfigure the end points,
see page 90.
There may have been a power failure. Reconfigure the switching times,
see page 93.
The end points may be displaced due to elongation of the belt.
Re-adjust the end points, see page 90.
The end points are not configured. Configure the end points, see
page 90.
Possibly the belt is wrapped around the reel incorrectly, see page 88.
The maximum running time of the drive has been exceeded, see
pages 79/103.
The motor is too hot. The roller shutter belt winder will be operational
again in approx. 1 hour.
EN
99