End Point Adjustment - RADEMACHER RolloTron Standard Series Operating And Assembly Manual

i

11. End point adjustment

IMPORTANT
The end points must be configured in order that the roller shutters stop at the desired upper and lower positions. It is imperative that
both end points are configured, otherwise malfunctions may occur.
Set the upper end point
1.
Press and hold the Set key.
2.
Press the [ Up ]-key once.
The roller shutter moves upwards.
3.
Release the Set key, ...
...as soon as the roller shutter achieves the
desired position for the upper end point.
The roller shutter stops and the upper end
point is stored.
90
NOTE
Tighten the belt slightly, until it is ten-
sioned by the weight of the roller shutters.
Setting the wrong upper end point
may lead to overload or damage
the roller shutter belt winder or
the drive.
◆ Do not set the upper end point
right up to the limit stop.
◆ Release the key promptly and
never allow it to extend beyond
the respective end point.
NOTE
The set button is slightly recessed
in the front panel. Please use a thin
pen or similar tool in order to press
the set button.
Example:
Standard device
EN