Delta AS Series Operation Manual page 353

4) The list below shows the Delta network products for the CANopen network.
Product
C h a p t e r 1 0 C A N o p e n F u n c t i o n a n d O p e r a t i o n
Model
AS332T-A
AS332P-A
AS324MT-A
AS320T-B
AS320P-B
AS300N-A
AS228T-A
AS228P-A
AS228R-A
AS218TX-A
AS218PX-A
AS218RX-A
DVP32ES200RC
DVP32ES200TC
DVPCOPM-SL
IFD9503
DVPCP02-H2
IFD6503
Function
The AS300 series PLC can function as the
CANopen master or slave when you install an
AS-FCOPM function card. The AS-FCOPM is
equipped with a 120 ohm resistor controlled by
a switch.
AS200 Series PLC is built with CAN
communication port. The CAN port conforms
to the basic communication protocol
CANopen DS301. It supports master and
slave modes. The CAN communication
terminal is equipped with a 120 Ω resistor.
You can use a short circuit to use this resistor.
The DVP-ES2-C series PLC has a built-in
CAN interface. It can function as the
CANopen master or slave.
DVPCOPM-SL is a module connected to the
left side of an S series PLC. It can function as
the CANopen master or slave. The PLCs that
you can connect to the DVPCOPM-SL are the
DVP-28SV, DVP-28SV2, DVP-SX2, DVP-
SA2, and DVP-EH2-L.
The IFD9503 gateway converts CANopen to
Modbus, and connects a device (with an RS-
232 or RS-485 interface) that conforms to the
standard Modbus protocol to a CANopen
network. You can connect up to 15 devices.
The CANopen slave module is connected to
the right side of an EH2 series PLC. It can
connect the EH2 series PLC to a CANopen
network.
This analyzes CANopen network data, and
has ports both ends for a CAN interface and
a USB interface. Use it to monitor CAN
network data, or allow CAN nodes to transmit
the data. The product is used with the
Netview Builder software.
10
1 0 - 9