Delta AS Series Operation Manual page 244

A S S e r i e s O p e r a t i o n M a n u a l

Steps to set up and download parameters
1. Create a data mapping table (*):

Right-click the COM port on the Ethernet Scanner, and then click Data Mapping to open the Data Mapping
Table.
The system creates a Data Mapping Tab, shown for Network_0.
2.
Set the Data Mapping Parameters

Type the parameters in the data mapping table. See below for examples
a) Reading D500–D599 from the Adapter with the IP address 192.168.1.2 to the D10000–D10099 in the
_9
Scanner.
b)
Writing D20200–D20299 from the Scanner to D100–D199 in the Adapter with the IP address
192.168.1.1
9 - 3 6
Network_0 Data Mapping Tab
N e tw ork_ 0 D at a Ma pp i ng Ta b le