Gigabit Ethernet Line Cards - Cisco ASR 9000 Series Installation Manual

Overview

100-Gigabit Ethernet Line Cards

Caution It is strongly recommended to wait for 60 seconds before successive insertion or removal of optics. Failure
in following this recommendation may affect the functionality of optics.
1-Port 100-Gigabit Ethernet Line Card with CFP
The 1-Port 100-Gigabit Ethernet (GE) line card provides one CFP cage for an CFP Ethernet optical interface
module that operates at a rate of 100 Gbps. The CFP module can be a 100GE multimode connection.
The 1-port 100GE line card is available in either an -SE (Service Edge Optimized) or -TR (Packet Transport
Optimized) version. Both versions are functionally equivalent, but vary in configuration scale and buffer
capacity. The CFP cage has an adjacent Link LED visible on the front panel as described in
on page
The following table lists the supported optics and connectors for 1-port 100GE line card.
Table 11: Supported CFP Optics for Cisco 1-Port 100GE Line Card
Part Number 100-Gigabit Ethernet CFP Modules
CFP-100G-LR4 100 GE long-reach over 4 WDM lanes (LR4) optics (single-mode fiber)
CFP-100G-SR10 100 GE over 10 short-reach optical lanes (SR10) optics (multimode fiber)
The following figure shows the 1-port 100GE line card front panel and connector.
138.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
100-Gigabit Ethernet Line Cards
Line Card LEDs,
Maximum Distance
10 km
100 m
35