National Instruments MXI-Express x1 Series User Manual page 25

Table 2-1. MXI-Express x1 Connectivity Support From a Host PC Using a Copper or Fiber Cable
From Host
Slot Type Product
PCI NI PCI-8361
NI PCI-8366
PCI Express x1 NI PCIe-8361
PCI Express x1 NI PCIe-8362
ExpressCard NI Express
Card-8360
Industrial NI 3100/3110
Controller
* Product has an integrated MXI-Express x1 port.
†
These configurations are not supported, even though the front panel MXI connectors are mechanically compatible. For these configurations the boards
will likely report a valid cable link via the front panels LEDs. Since these link scenarios expose a possible data integrity issue that may not be obvious to
the user, National Instruments strongly recommends against using these configurations.
Note: For installation instructions and other information concerning the NI PXI-1033, NI PXIe-1073, NI VXI-8360T, NI 9157, NI 9159, and the
NI 3100/3110, refer to their respective user manuals.
Note: For full PXI or PXI Express functionality, refer to the
for more information.
Note: PCI Express host slots will give better throughput and latency performance than PCI slots.
PXI Chassis
NI PXI- NI PXI- NI PXI-
8360 8368 1033
—

—

—

—

—

*
—

Software Installation and Configuration
Targets
VXI
Chassis PXI Express Chassis
NI VXI- NI PXIe-
*
8360T 8360
— † — † —
— — —
  
  
  
  
MXI-Express RIO
NI PXIe-
*
1073 NI 9157
† — † —
— —
 
 
 
 
Installation and
section of Chapter 3,
* *
NI 9159
—
—




Configuration,