Ni Pci-8366 Low-Profile Bracket Installation Instructions - National Instruments MXI-Express x1 Series User Manual
Mxi-express x1 multisystem extension interface for pci, pci express, compactpci/compactpci express, expresscard, and pxi/pxi express bus computers, ni pci-8361, ni pxi-8361, ni pxi-8368, ni pci-8366, ni pxi-8364, ni pxie-8360, ni pcie-8361, ni pxi-8366, n
Table of Contents
Advertisement
NI PCI-8366 Low-Profile
Bracket Installation
Instructions
This appendix describes how to install a low-profile bracket on the NI PCI-8366. For
specifications for the NI PCI-8366, refer to Appendix C,
Installing the NI PCI-8366
1.
Disconnect the fiber optic cable from the cabled PCI Express connector.
2.
Move the release lever downwards until it is pointing towards you.
3.
Gently pull the release lever toward you to release the catch mechanism of the SFP module.
The SFP module should easily slide out of the receptacle as shown in Figure D-1.
3
2
1
1
Release Lever
2
Cabled PCI Express Connector
4.
Remove the two 4-40 × 1/4 inch Phillips head screws that attach the standard height bracket
to the card as shown in Figure D-2. Set the screws aside to re-use when installing the
low-profile bracket.
Figure D-1. SFP Module Removal
Specifications for Legacy
4
3
SFP Module
4
SFP Receptacle
© National Instruments | D-1
D
Products.
Advertisement
Table of Contents
