Ni Pxie- - National Instruments MXI-Express x1 Series User Manual

Table 2-2. MXI-Express x1 Daisy-Chain Connectivity Support From a Chassis Using a Copper Cable
From Chassis
Slot Type Product
PXI or NI PXI-8364
PXIe Hybrid
NI PXI-8367
PXI Express or

NI PXIe-8364

PXIe Hybrid
ExpressCard ‡ NI ExpressCard-8360
* Product has an integrated MXI-Express x1 port.
These configurations are not supported, even though the front panel MXI connectors are mechanically compatible. For these configurations the boards
†
will likely report a valid cable link via the front panels LEDs. Since these link scenarios expose a possible data integrity issue that may not be obvious to
the user, National Instruments strongly recommends against using these configurations.
**
Daisy-chaining from PXI Express or ExpressCard slots will give better throughput and latency performance than PXI or PXI Express hybrid slots.
‡ ExpressCard slot of an embedded controller that is installed in the chassis to be daisy-chained from.
Note: For installation instructions and other information concerning the NI PXI-1033, NI PXIe-1073, NI VXI-8360T, NI 9157, and NI 9159 refer to their
respective user manuals.
Note: For full PXI or PXI Express functionality, refer to the
for more information.
PXI Chassis
NI PXI- NI PXI- NI PXI-
8360 8368 1033
 — —
†
—  —
 — 
 — 
Software Installation and Configuration
Targets
VXI
Chassis PXI Express Chassis
NI VXI- NI PXIe-
*
8360T 8360
— —
† †
— —
 
 
section of Chapter 3,
MXI-Express RIO
NI PXIe-
* *
1073 NI 9157 NI 9159
—  
†
**
— — —
  
  
Installation and Configuration,
*
**