Electrical Connection; Instruction For Installation - ROSIERES RFE9163/1MIN Use And Maintenance Instructions

Electrical connection

Insert the plug into a power socket with a third contact corresponding to the earth socket that
must be connected in an efficient manner.
For plugless models, fit a standard plug on the cord that is able to withstand the load
indicated on the typeplate. The earth wire is marked with yellow and green colours. This
operation must be carried out by a qualified technician.
If the socket is incompatible with the appliance's plug, have a qualified technician replace
the socket with a suitable one. The connection to the mains can also be made by placing an
omnipolar switch between the appliance and the mains with a minimum opening distance of
3 mm between the contacts, suitably sized for the load and satisfying the relative standards.
The yellow-green earth wire must not be interrupted by the switch.
The socket or omnipolar switch used for the connection must be easily accessible from the
installed appliance.
Important: during installation, position the power cord so that no point reaches
temperatures more than 50°C above room temperature.
The appliance satisfies safety requirements set by current regulations.
The electrical safety of this appliance is ensured only when the same is correctly connected
to an efficient earthing system as required by current electrical safety standards (if in doubt,
request a qualified technician to thoroughly check the system).
Important: the manufacturing company accepts no responsibility for any damage to
persons or property resulting from failure to connect the earth line.
CAUTION:
The power supply voltage and frequency are indicated on the typeplate.
Check that the electrical capacity of the system and power supply sockets is suitable
for the maximum power of the appliance indicated on the plate. If in doubt, contact a
qualified technician.

INSTRUCTION FOR INSTALLATION

To ensure the built-in appliance works correctly, the unit must correspond to certain
characteristics.
The panels of the units near the oven must be made of heat-resistant material.
Especially as regards veneered wooden furniture, the glues must withstand temperatures
of up to 120°C:
plastic or binders that cannot withstand this temperature will deform or come unstuck.
In compliance with safety regulations, once the appliance is built in, contact with
electrical components must no longer be possible.
All protective coverings must be fixed so they cannot be removed without the aid
of a tool.
The oven can be used below the worktop or in a column unit by means of 4 screws.
Please see the drawing on the following page.
35