Removing The Oven Door - ROSIERES RFE9163/1MIN Use And Maintenance Instructions

Removing the oven door (fig.1)
To make it easier to clean the oven, the door may be removed.
The hinges A are fitted with 2 mobile U-bolts B which block the door when it is
completely open if they are hooked onto sections C of the hinges.
After this has been done, the door must be lifted up and taken out.
When carrying out this operation, hold the sides of the oven door beside the hinges.
To refit the door first slide the hinges into their grooves.
Lastly, before closing the door do not forget to detach the 2 mobile U-bolts B
which were used to hook the 2 hinges.
Note: Clean the oven door using non-abrasive products.
Removing the oven door inner glass panel (fig. 2)
Do not use any abrasive medium that could cause damage. Remember that if the
surface of the glass panel becomes scratched, this could lead to a dangerous failure.
To remove the oven door inner glass panel, use a coin to perform a levering action
in the two grooves (A) until the two pins (B) are realeased from their housing.
Then raise the glass and take it out from the top.
To refit the door, repeat the two previous operations in reverse.
Reinsert the glass by resting it on the inner door and pushing it in. press on the
glass until the pins slot back into their initial position.
Fig. 2
Fig. 1
33