Table of Contents
Advertisement
Installation
6. Repeat with the other end panel.
7. Fit the center panel with its step edges overlapping
both end panels.
8. Slide the end panels towards the center and slide
the fi rebox end panel against the rear to eliminate
any gaps between them.
9. Ensure all panels are square against the back wall of
the fi rebox.
10. Push the 3 panel supports against the top of each
section and tighten the screw.
11. Two brick retainers and three glass retainers are
supplied with the panels. They are used to hold the
bottom of the rear panels against the rear wall of
the fi rebox. The brick retainers have a shallower
return and the glass retainers have a deeper return.
Brick retainer with a
shallower return
12. Hook one retainer to the back of the fi rebox rear
wall and fold it over the lip on which sits the ceramic
panel so it holds the panel against the rear wall.
13. Repeat with the other panels.
14. Re-install the rear media tray (3 screws).
Liners
Glass retainer with a
deeper return
35
Advertisement
Table of Contents
