Table of Contents
Advertisement
Available languages
Available languages
3.2
Operation
DE
How To Use
(Before Use)
When using the meter for the first time, set the attached 4 pieces of dry cells (R-6). For this purpo-
se, while pressing the area of "OPEN" on the battery box cover on the back of the main unit, slide
EN
it. Then set the cells with the po larities facing the correct directions.
Caution!
FR
1. Setting the probe
u
u
IT
Caution!
ES
2. Powering the meter
To use the meter, press the ON/OFF switch.
Caution!
CZ
(Change of display when power is turned on)
Immediately after the power is turned on, the display shows the start demon stration. While
PL
it is displayed, the operation of all switches other than the ON/OFF switch is not accepted.
RU
lmmediately after power on
3. Selecting the measuring mode
When the power is turned on, the equipment is always started in thc DC X 1 measuring mode.
ZH
When the MODE switch is pressed, the measuring mode changes as follows. Select a suitable
mode according to the purpose of meas urement.
The modes can be changed over only in the REAL mode.
24
Be sure to use the specified dry cells (R-6) only. The use of unauthorized
cells may result in an electrical failure to disable the use of the meter.
Ensure the Tesla meter is set to OFF.
After making sure the connector at the top of the case and pins of the probe plug are free
of foreign matter such as dust, gently insert the probe until it touches the bottom while
aligning the plug and the connector.
If foreign matter such as dust is adhering or the plug and the connector are not
aligned properly, an electrical failure such as short circuit may result, disabling
the use of the meter.
When operating the switches, be gentle in pressing them. lf they are operated
roughly or pressed with a sharp object, a failure may result to disable the use of
the meter.
End of demonstration display
Advertisement
Chapters
Table of Contents
