Lat Pulldown - Nautilus Inspiration 4-Station Owner's Manual

LAT PULLDOWN

26. Use a 5mm allen key to loosen
the four (4) set screws located at
the bottom of the weight stack
guide rods, once the set screws
are loose the guide rods should
drop down.
27. Swing the guide rods forward
out of the machine then remove
the guide rode stop caps.
28. Starting from the bottom of
the weight stack (731-3204),
carefully slide each weight plate
down the guide rods.
29. Once the entire weight stack has
been installed, replace the guide
rod caps, reinstall the rods back
into place, and tighten the set
screws loosened in step 26.
Page 16
F . 25
ig
F . 26
ig
START
F . 27
ig