At The End Of The Work - Fimap GENIE BS Use And Maintenance Manual

At the end of the work, and before carrying out any type of maintenance, perform the following operations:
1. Turn off the solenoid valve switch (3)
2. Raise the rear squeegee and lower the front one by raising the command levers
3. Turn off the suction switch (2)
4. Turn off the brush / main switch (1)
5. Take the machine to the location designated for draining the water.
6. Remove the recovery tank, then remove the bayonet cap and tilt the tank to empty it
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of
serious injury to hands.
ATTENTION: this operation must be carried out with the machine switched off and the
battery connector disconnected
7. Take out the debris hopper and clean it carefully
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of
serious injury to hands.
8. The action of lowering the front squeegee (lever up) also serves the purpose of raising the brushing unit at the end
of the work in order to prevent the brushes becoming deformed.

AT THE END OF THE WORK

17