Overflow Device; Forward Movements - Fimap GENIE BS Use And Maintenance Manual

15. PRE-WASHING FUNCTION: adjust the latch on the levers in order to make them independent of each other.
Raise the left-hand lever so the rear squeegee rises up. Lower the right-hand lever so the front squeegee rises up.
In this way, only the brushes are in action, and a pre-wash is carried out on the floor. Alternatively, by shutting off
the water, the machine can be used exclusively to collect dirt.
16. press the main switch (1) and verify that the green indicator light comes on
17. press the suction switch (2)
18. press the solenoid valve switch (3)
At this point the machine can operate at full efficiency until all the detergent solution runs out, or until the batteries run
flat, by means of the operating lever that drives the brushes (4)

2. OVERFLOW DEVICE

The machine is fitted with a ball filter which is activated when the recovery tank is full, causing the suction tube to close.
In this case, it is necessary to switch off the machine and empty the recovery tank.
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of
serious injury to hands.

3. FORWARD MOVEMENTS

The traction of these machines is obtained by means of the front brush of the base which, by working at a slight
inclination, is able to drag the machine forwards.
ATTENTION: When making even brief reverse movements, verify that the rear squeegee is
raised.
ATTENTION: When making even brief forward movements, check the front squeegee is
raised.
WORK
16