Install The Beam Lights - FAAC B680H Manual

10. INSTALL THE BEAM LIGHTS

Installation of an LED bar light kit increases visibility of the bar.
Proceed to install following the instructions contained in Fig. 19 and securing the connection cable according to the path shown, using the
holes to secure it with tie-wraps.
Connect the kit to J16 on the electronic board and configure it according to the available modes (refer to Par 4.12 in the control board section)
NOTE: Make sure the two connector make good contact with the conductors inside the cord. Should the bar lights still not turn
on, reverse the connection polarity.
a
c
Fig. 19
b
d e
14