Regency B41XTCE-NG11 Manual page 5

B41XTCE-11 Gas Fireplace
7. Non-combustible material (ie. tile, slate, etc) may be brought up to the edge of the glass door of the unit. Minimum clearances must be adhered
to, this will assure ease of glass door removal and access to the lower panel.
NOTE: Non-combustible finishing materials may be of any thickness desired.
NON-COMBUSTIBLE BOARD SUPPLIED W/UNIT
No Combustible
Materials in this Area
NO FACING OR
FINISHING MATERIAL
IN THIS AREA
4-1/8"
[105mm]
Minimum Clearances for Finishing Materials
IMPORTANT FINISHING DETAIL NOTE:
Before placing unit into final position - it is important to know the
total thickness / height of finished hearth (tile, carpet, etc.) The
base of the fireplace, 4 sided faceplate or mantel should be level
or higher than the finished hearth height.
46-11/16"
[1186mm]
6" [152mm]
11-5/8"
[295mm]
3-9/16"
[91mm]
38-7/16"
976mm
Gas Fireplaces
No Combustible
Materials in this Area
J Style trim or metal
corner bead may be
used to finish edges
38-7/16"
976mm
Note:
All non-combustible facing material should butt up cleanly
to the flanges around the firebox opening.
Rough edges may be visible from an angle.
To maintain a clean finished edge - facing material edges
may be finished with a J-style trim or metal corner bead (both
materials available at your local building or hardware store).
IMPORTANT: Materials used must be NON-COMBUSTIBLE.