Accessing The Security System Using An On-Premises Telephone - ADEMCO TeleCommand User Manual

Step-by-Step Procedure
1. Activate the telephone and listen for dial tone.
2. Press the [#] key within 5-seconds.
Pressing the # key activates TeleCommand and prompts you to
enter your 4-digit TeleCommand code.
3. Enter your 4-digit TeleCommand code to access TeleCommand
and hear system status.
There is a 20-second time limit in which to enter TeleCommand
User Code. After this time expires, TeleCommand disconnects.
4. Listen to the Status Report.
5. To perform a Security System Command, enter your security
system 4-digit user code and then make the same key entries
normally performed at a local security system keypad.
6. Hang up the telephone when finished or press [#] + [*] + [*] to
disconnect from TeleCommand.
If Your Home Telephone System Does Not Subscribe To Multi-Frequency
Service: Access to TeleCommand and your security system can only be
provided if the telephone is multi-frequency capable (i.e. the telephone is
equipped with TONE/PULSE switch).
TONE/PULSE switch on your telephone to TONE and then return it to PULSE
when the TeleCommand session is completed.
Accessing the Security System
Using an On-Premises Telephone
To use TeleCommand, set the
5