Protection Against Outside Tampering - ADEMCO TeleCommand User Manual

Program the module as follows:
1. Pick up your home telephone connected to the same line as
TeleCommand and press the [#] key within the initial 5 seconds of
dial tone to activate TeleCommand.
2. Enter your TeleCommand User Code, ex. [1] + [2] + [3] + [4].
TeleCommand will announce your security system status.
3. Press [#] + [0] + [0] to enter the programming mode:
TeleCommand will prompt you to select Zone Descriptor.
You may select the zone descriptor options in any order. TeleCommand
will repeat the prompts from the beginning of the menu each time a
prompt has been selected and a valid entry made.
TO PROGRAM
Zone Descriptor

Protection Against Outside Tampering

TeleCommand is locked out automatically for 20 minutes as a result
of possible tampering caused by improper keying of codes on a call-in
from outside. If this occurs repeatedly over a short period of time,
exercise caution (if the improper keying was not caused by you or
another authorized user). An unauthorized person may be attempting
to access your security system from outside.
Miscellaneous Functions (cont)
PROGRAMMING ZONE DESCRIPTORS
PRESS ENTER
[6] 3 digit zone
number
THEN TO
RECORD = Press [1]
ERASE = Press [2]
PLAYBACK = Press [3]
SELECT ZONE # = Press [4]
PREVIOUS MENU = Press [8]
EXIT PROGRAMMING = Press
[9]
Two beeps will sound,
confirming program mode
exited.
17