Table of Contents
Advertisement
You may terminate a TeleCommand session at any time by ending the
call. TeleCommand access will also be terminated under the following
conditions:
•
If no tones have been received and the security system has made
no announcements for 20 seconds.
•
Immediately if an alarm dialer report is triggered in the security
system. This ensures immediate notification of the alarm to the
alarm monitoring station. Termination may also occur if the valid
telephone and system security codes had not already been entered
when other types of dialer reports are triggered.
If you terminate a TeleCommand session, you should wait approximately 2
minutes prior to calling for access again, otherwise you may receive a busy
signal.
Conditions that Terminate
a TeleCommand Session
15
Advertisement
Table of Contents
