Accessing The Security System Using An Off-Premises Telephone - ADEMCO TeleCommand User Manual

Accessing the Security System
Using an Off-Premises Telephone
The security system can be accessed from any outside multi-frequency
telephone.
Step-by-Step Procedure
1. Dial the premises telephone number.
If there is no
answering machine
present:
Following the preset
number of rings set by
your installer, you will
be prompted to enter
your 4-digit
TeleCommand code.
Press the # key (within
5 seconds) and enter
your TeleCommand
code.
If someone at home
answers the
telephone:
Press the # key within
5 seconds of the
pickup. Notify that
person you are about to
access the security
system and that they
may hold on or hang
up. Enter your 4-digit
TeleCommand code.
After you have pressed the [#] key and entered your 4-digit TeleCommand
Code, TeleCommand announces your security system status.
6
If you are using a call
answering service
from your telephone
service provider:
Wait for the first ring
and hang up. Wait 10
seconds and dial the
premises telephone
number again. You will
hear your security
system pick up and a 2-
second tone burst.
Wait for the tone burst
to end and press the #
key. Once the # key is
pressed, wait for the
phrase "ENTER YOUR
4-DIGIT PHONE
CODE" to end. Enter
your 4-digit
TeleCommand code.
If your home
answering machine
responds to the call:
Press the # key within
the first 5 seconds of
the out going message.
You will be prompted
to enter your 4-digit
TeleCommand code.
Enter your 4-digit
TeleCommand code.