Nakayama MB2000 Owner's Manual page 11

 Children must be supervised to make sure that they do not play with the device.
Electrical safety
 The mains voltage must correspond to the one marked on the technical data plate
(230V~50Hz). Do not use other sources of power.
 The use of a safety circuit-breaker is recommended for the power supply line for
an intervention range of 10 to 30 rated mA. Consult a reliable electrician.
 Never pass the appliance over the extension cable that the appliance is working,
as this could cut the cable. Mark sure you always know where the cable is.
 Use the special cable holder for the connection of the extension cable.
 Never use the appliance when it is raining. Try to prevent it from getting wet or
being exposed to humidity. Do not leave it outside overnight. Do not cut damp or
wet grass.
 The power supply cable should be checked regularly and before using it each
time, make sure the cable is not damaged or old out. If the cable is not in good
condition, do not use the appliance; take it to an authorized service center instead.
 Only use an extension cable that is suitable for outdoor work. Keep it away from
the cutting area, from damp, wet or oily surfaces or with sharp edges and away
from heat and fuels.
 Design of the connection cable according to IEC 60245 (H 07RN-F) with a core
cross-profile section of at least
2
1.5 mm for cable lengths up to 25 m
2
2.5 mm for cable lengths over 25 m
Before starting up
Intend use
This appliance is only intended as an electric tiller for aerating lawns and grassy
areas in private domestic and hobby gardens.
It is not designed for use in public areas, parks, sports areas, and in agriculture and
forestry.
Using the appliance for any other purpose is considered incorrect and unapproved.
The manufacturer is not liable for any damage or injury resulting from such use. The
user is entirely responsible for any associated risks.
Double insulation
The appliance has double insulation. This means that all external metal parts are
insulated from the electrical supply.
This is achieved by introducing an insulation layer between electrical and mechanical
parts. The double insulation guarantees you the greatest possible safety.
Overload protection
The appliance is equipped with a mechanical overload protection sytem. In case the
appliance is blocked by a foreign object, the connection of the motor with the tine
shaft will be cut off automatically.
 Swith off the motor,
 Remove the blockage. Replace tines if necessary before re-start.
Assemble
Attaching the bar (Fig 2)
Insert on side of bar lower section (5) to the hole on the mahince housing (6),
11
www.NakayamaTools.com