Table of Contents
Advertisement
4. Remove the Intake muffler from the foam section.
5. Gently lift up the foam section, while feeding the protruding wires
through the foam, and remove.
6. To replace the foam section and intake muffler, repeat steps 1-5 in
reverse order.
Personal Ambulatory Oxygen System Provider Technical Manual
Figure 33
Figure 34
IV.
Removing/Replacing the
Compressor Assembly
1. Remove the Top Exhaust Port by gently pulling upward.
2. Remove the Bottom Exhaust Port by slightly lifting up on the
Exhaust Blower Outlet and pulling up the Bottom Exhaust Port.
3. Disconnect the Compressor Assembly power connections circled
below.
Using tweezers or small pliers to grab the connector is
Note:
recommended.
Figure 35
Figure 36
Figure 37
20771733 D 27
Advertisement
Table of Contents
