Related Manuals for CAIRE STROLLER
Summary of Contents for CAIRE STROLLER
- Page 1 troller T R O L L ® print P AT I E N T O P E R AT I N G I N S T R U C T I O N S ™ P R I N T...
- Page 2 • Applicable EMC information can be found in the cause other materials to burn faster than normal. Stroller/Sprint Service Manual at www.cairemedical.com. This hazard, along with the low temperature of Explanation of Other Symbols liquid oxygen, warrants certain safety precautions.
- Page 3 Patient’s Records Patient’s Name Prescribed Oxygen Flow Setting Doctor’s Telephone Number Distributor’s Name Person to Contact Distributor’s Emergency Telephone Number Special Instructions...
- Page 4 Warning: This device is not intended for life sustaining use. Filling Instructions 7-10 Operating Instructions 11-15 Caution: Use the Stroller/Sprint only as directed by your doctor. Additional Information Warning: If you feel the equipment is not working Specifications: properly, call your health care provider. Do not attempt to repair or adjust the units yourself.
- Page 5 Stroller/Sprint, which provides supplementary oxygen as prescribed by your physician. This POI contains the instructions for using the Stroller/Sprint. Refer to the POI supplied with the stationary unit for its operation. The Liberator is the larger container and is intended for stationary use.
- Page 6 Stroller/Sprint Controls 1. Electronic Liquid Level Gauge 2. Electronic Liquid Level Switch 3. Mechanical Liquid Level Gauge 4. Flow Control Knob 5. Oxygen Tube Connector 6. Vent Valve 7. Fill Connections (see next page for QDV Identification) 8. Carrying Strap with Shoulder Pad 9.
- Page 7 Stroller/Sprint Quick Disconnect Valve (QDV) Identification Portable Connector: Stationary Connector: QDV Style: CAIRE LINCARE CRYO2 LIFE-OX PENOX TAEMA Side Fill (UC) SF Locking TF Locking TF Push-on...
- Page 8 3. Position the fill connector in the upright position over the stationary unit’s connector. Step 3 4. a. If your connector is a push-on: Lower the Stroller/Sprint unit on to the stationary until you feel the connector engage. Step 4a Step 4b Step 4c...
- Page 9 2. Make sure the flow control knobs on both the Step 3 Stroller/Sprint and reservoir are in the off (0) position 3. Make the Stroller/Sprint fill connector is in the upright position to the stationary connector. 4. Rotate the Stroller/Sprint counterclockwise ( ) until you feel the pin and slot engage.
- Page 10 Stroller/Sprint throughout the fill. most completely, but wastes some liquid oxygen. 6. Open the vent valve to begin filling your Stroller/Sprint. You should hear some oxygen escaping; do not worry. The hissing sound you hear is perfectly normal.
- Page 11 Stroller/Sprint Closing the valve at the first sign of liquid discharge Warning: Do not operate Stroller/Sprint while does not fill the Stroller/Sprint as completely, but saves attached to the stationary unit. liquid oxygen. Warning: Should the leakage be excessive to the point that a stream of liquid is present, leave the area 9.
- Page 12 3. Turn the flow control knob on top of the Stroller/Sprint clockwise until the prescribed flow rate (numeral) is visible in the knob “window” and a positive detent is felt.
- Page 13 Stroller/Sprint 5. Use the following chart as a guideline to determine the length of time the Stroller/Sprint will operate: FCV Setting Model Sprint Nominal 30:00 20:50 12:55 9:25 7:20 5:10 4:00 3:10 2:40 2:05 1:40 1:25 Stroller Nominal 60:00 41:40...
- Page 14 Gen 4 Gauge: Press the green operate button on the face of the gauge. Read the arc of LEDs, which indicates content level. Caution: The Stroller/Sprint is empty if only the last segment of the light bar is lit. G N 3 Gauge If the Low Battery indicator lights up when the button is depressed, notify your health care provider.
- Page 15 Stroller/Sprint 6b. To verify the level of liquid oxygen in unit with the mechanical liquid level gauge: • Support the unit, by the fabric strap, directly above the black contents indicator spring scale chamber. • Allow the unit to stabilize (i.e. not bounce up and down), then read the exposed colored scale for approximate liquid oxygen contents.
- Page 16 Stroller/Sprint 8. After the unit is empty and has warmed up to room • Remove the pad from the cup and wring out any temperature, remove any moisture from the absorbed moisture. Allow the pad to dry completely condensation cup: before replacing it in the cup.
- Page 17 Note: Note to health care provider – for reprocessing accommodates both the procedure, see applicable Stroller or the Sprint. service manual. W W E E E E E E a a n n d d R R o o H H S S...
- Page 18 2 2 0 0 A i r p o r t I n d u s t r i a l D r i v e S t e 5 0 0 B a l l G r o u n d , G A 3 0 1 0 7 U .