Start-Up; Settings On The On/Off Switch - WAGNER FOLIATEC Spray system Manual

Table of Contents

Advertisement

Available languages

Available languages

GB
Sprayed material
Spray film, paints containing solvents and water-soluble
paints, primers, vehicle coating paints, thick-film glazes
2. If the convey capacity is too low, add 5 - 10 % dilution step-by-step until the convey
capacity fulfils your requirements.

9. Start-up

Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
Unscrew the container from the spray gun.
Aligning suction tube. (Fig. 2)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 2 A)
When spraying objects overhead, turn suction tube back. (Fig. 2 B)
Set the container on a sheet of paper, pour in the prepared coating material and
screw the container tightly onto the spray gun.
Insert the air hose tightly in the connections on the machine and the spray gun (Fig. 3,
a + b). The position of the hose is not relevant.
Set up the spray device at least 5 metres away from the room in which the spraying is
being executed.
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
Push the ON/OFF switch at the device.
It is advisable to test spray cardboard or a similar material in order to determine the
material quantity and the spray pattern.

10. Settings on the ON/OFF switch

The spray system has a multi-stage On/Off switch. This allows the power of the unit to
be adjusted to the material used, in order to optimise the spray pattern and reduce the
spray mist.
Switch in Position "0"
Switch in Position "1"
Switch in Position "2"
For thin materials the spray mist can be reduced and energy saved by
i
switching to speed stage 1.
20
Thinning recommendation
 Unit switched off
 Unit switched on to speed stage 1
(for working with very thin materials)
 Unit switched on to speed stage 2
(for working with more viscous materials)
dilute by 0 - 10 %
03/2015

Advertisement

Table of Contents
loading

Table of Contents