Keysight Technologies 34450A Programmer's Reference Manual page 88

2 SCPI Programming
Down range at:
Up range at:
— If the input signal is greater than can be measured on the selected range (manual ranging), the
instrument gives an overload indication : "OL" from the front panel or "9.9E+37" from the remote
interface.
— For the available measurement functions in dual display mode, refer to the Keysight 34450A User
Guide.
Examples
The following program segment configures the instrument for AC current measurements. The READ?
command places the instrument in the "wait-for-trigger" state, triggers a measurement, and then sends
the reading to memory and the instrument output buffer. The default range (auto range) and resolution
(5½ digits) are used for the measurement.
CONF:SEC:CURR:AC
READ?
Typical Response: +8.54530000E-02
See Also
CONFigure:SECondary?
FETCh?
INITiate[:IMMediate]
READ?
88
<10% of range
>120% of range
Keysight 34450A Programmer's Reference