End Flight; Additional Remarks; Camera Gimbal Removal And Installation; Compass Calibration - Walkera Voyager 5 Quick Start Manual

13.0 End flight

1. Manual Landing, AUTO Landing or Return to Home function landing.
2. First, turn off the 3 batteries one by one, then turn off the remote controller.
3. Finally, remove the battery from the aircraft.

14.0 Additional remarks

14.1 Camera Gimbal Removal and Installation

Screw
hole
position
Removal
Loosen the M3x3 fixed gimbal screw first, then
turn the gimbal nut clockwise to the unlocked
position to pull down the Gimbal

14.2 Compass Calibration

If there is circles or drift in flying, please calibrate the compass.
(the motor must be locked and the red and blue LED lights turn off )
Please calibration outdoors and far away from strong electromagnetic interference.
The compass calibration steps are as follows:
Keep for 5 seconds
Place right/left sticks at lowest
location, toggle them inward and
keep for 5 seconds until the aircraft's
red LED lights flash quickly .
In case of failure to calibrate, please follow above procedure to repeat calibration.
Installation
Put the white mark position column aim at the white mark position
hole, and put the gimbal in the install position upwards embed.
Rotate the gimbal nut to the locked position following to the direction
of the arrow.Tighten M3x3 screw to fix the gimbal.
Tail toward operator
Horizontal 360°rotation of aircraft
until red LED lights turn off and
blue LED lights flash quickly.
Quick Start Guide
Ground heading
Vertical 360° rotation of aircraft
(heading down) until blue LED
lights turn off, indicating successful
calibration, and place aircraft at a
horizontal location
18